All in One Solar street lights install

all in one solar street light install

Although the All in One Solar street lights install is becoming more easily, there are still many notices that need attention during the installation process.

The preparations of All in One Solar street lights install are as follows:

1. Selection of disassembly and assembly locations

2. Installers and tools

3. Inventory the lamps according to the shipping list

4. Check the nameplate on the back of the solar cell module, and check whether the specifications, models and quantities meet the design requirements

5. Check whether the surface of the solar cell module is damaged or scratched
Visual inspection of the battery at the installation site

When the lower light pole component is placed, the upper end of the lower light pole component needs to be supported by an iron frame to facilitate the installation of the upper light pole component.

All in one solar street light features

All in one Solar LED street lights are mainly composed of solar battery components, controllers, batteries, LED light sources, light poles and structural parts. Assemble the solar LED street light with reference to the solar street light assembly drawing.

All in one solar street lights arm install.

solar street light with pole

Use a thin iron wire to fasten the bare sheath wire end on the lower light pole and wrap it with black tape; the other end of the thin wire passes through the lamp arm assembly; slowly pull the thin wire at the top of the lamp arm assembly to make the fine wire Drive the sheath wire through the lamp arm assembly.

And at the same time, the lamp arm assembly gradually approaches the lower lamp post until the panel on the lamp arm is aligned with and close to the lamp arm boss on the lower lamp post, and then the lamp is secured with a suitable bolt The arm assembly is on the lower light pole.

When fixing the lamp arm assembly, avoid the lamp arm assembly from squeezing the sheath wire and causing the sheath wire sheath to be damaged or even cut off. Disconnect the thin wire from the sheath wire.

All in one solar street lights light body install

Check whether the light source specifications, models, and quantities meet the design requirements. If there are any discrepancies, the goods should be immediately replaced and replaced, and construction cannot be forced.

Check whether the surface of the light source is scratched, and whether the lamp is cracked or damaged, and some pictures are replaced immediately. Assemble, thread, and connect the light source and lamp cover to ensure that the positive and negative connections are correct. Verify if there is a problem with the light source and its wiring. If there is a problem, the cause should be found and resolved in a timely manner.

Assemble the upper and lower light pole components (upper and lower light pole components, light arm components, solar cell module fixing structures).

After disassembling the upper light pole component, the lower light pole component, the solar battery module angle steel fixing frame, and the light arm component, check them one by one to make sure that there are no scratches and paint can be assembled.

According to the assembly drawing of the solar LED street light structure, connect the angle steel fixing frame of the solar cell module with the upper light pole. The threaded connection should be uniformly stressed;

While connecting the solar street light bracket and the angle steel frame, a thin iron wire is used to guide the sheath wire from the light pole through the component bracket into the angle steel frame. The solar cell module protective plate is placed in an angle steel frame, and then the solar cell module is placed on the protective plate.

When installing solar cell modules, the junction boxes are all high. When the solar cell module is placed horizontally, the junction box should be moved closer to the light pole module.

Some solar LED street lights need to wear a sheath line when connecting the light pole to the angle fixing frame of the solar cell module. Pay attention to protect the sheath line from being damaged when threading.

The cable of the solar cell module should be put into the solar panel bracket according to the regulations. After putting it on, put on the glass glue to ensure that rainwater will not invade and adjust the direction and angle of the solar cell module.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *